FiestaMk7.com Owners Resource

Found degrading to earlier version of forscan worked with my elm adapter which I've used in previous years for PAT programming etc. Seems the newer versions arent the best for older adapters..anyway its working now. Removing the fog lamp relay 10 from the engine fuse box, connecting forescan and pro...

Hy,
I have the same car and am trying to get the front fogs going with forscan, seems enabled but no relay clicks and no volts at the plugs..Is the standard light switch sure for functioning even when its not got the logo on? I just ordered a replacement switch unit :-/

Hy all, Been working on the car with doors off for a couple of months, its back together but the drivers window and both mirrors are not operating, passenger side window ok, its a 2009 1.6 tdci. Is there a coding issue that could be looked at with forscan? Strange. All plugs checked ok, radio workin...

Guys I see there's a fault beep code symptom chart for low ie 4 sensor rear systems. My car is a high 8 sensor version with front and rear. I get a 3 second tone and then 6 beeps.. So, do the 6 beeps identify one of the front sensors perhaps? Can't find anything about the 8 sensor beep code. I thoug...

===PCM DTC None=== Successfull DTC reading, no error codes found Module: Powertrain Control Module ===END PCM DTC None=== ===OBDII DTC None=== Successfull DTC reading, no error codes found Module: On Board Diagnostic II ===END OBDII DTC None=== ===ABS DTC None=== Successfull DTC reading, no error co...

(OK) [10:03:56.917] Disconnected (WARN) [10:04:02.078] Checking FTDI #1:A90463IR... (OK) [10:04:04.503] Connection to adapter is established on FTDI #1:A90463IR (OK) [10:04:04.503] Adapter: ELM327 v1.4 (OK) [10:04:04.631] Connection to vehicle is established (OK) [10:04:07.010] Vehicle: Ford Fiesta ...

Hy all, I bought an ELM tool with the switch on and expected to read the dtc from the PAM module but it isnt listed at all. The Reverse park sensor lamp illuminates as reverse is selected followed by 6 loud beeps, the lamp then continues to flash until the ignition is switched off and reset. The rea...

From fordwiki; Dont know how accurate this is in relation to the 1.6tdci values but mine appears way out of spec? P1101 Error Description Mass Air Flow (MAF) Sensor Out of Self-Test Range The MAF sensor circuit is monitored by the PCM for an out of range air flow (or voltage) input. If during key ON...

Did some testing, engine off

MAF plug is four wire but no pins in pins A and F
Pin B =5.18v
Pin C=0v
Pin D=batt volts
Pin E=2.8v
Starting up at idle gives;

a decrease in Pin A to 5.09, all else remains the same, no change on revving the engine.

After watching the video link and examining the car, I realised the hing arrangement is different. Since last post I've taken sealant and sealed up ALL the exposed joining edges as I failed to believe the video content at first and thought the seams cant be wicking the water up and into the car ...b...